Tappet Tool for 5.8L/351W Engine

Original Tappet Tool designed by Harold Culpepper for 5.0 engines

Fits 5.8L/351W engines and also will work with GM/LS engines

This a great time saver for changing cams.
This tool goes through the push rod holes and pulls up the tappets with a high powered magnet, so the cam may be removed without taking the intake off. This saves 2.5 to 3 hours. (Set of 16 for each pushrod hole)

"I have changed  over twenty camshafts using the Tappet Tool. It's a time saver."
-Rick Anderson

Note* The magnet is attached to the rod via JB Weld epoxy and then heat shrinked over the connection. If the magnet becomes loose or a tool is dropped from a considerable distance on the ground it make cause the magnet to separate. If this happens simply add another dab of JB or similar strength epoxy and allow to dry which will allow the tool to function 100%.

Note* These are special order due to low order volume, expect 1-2 week turn around when order placed.