Autometer/Holley Digital Dash EZ Harness Professional Installation Kit for 87-93 Mustang

Shorter wire version of the Digital EZ harness to give you that professional touch for you aftermarket digital gauge installation!  Holley Digital Dashes and Autometer Digital Dashes have wiring connectors that already give you extended lengths of wire. (Works with New Vintage Dash Gauges as well) This short kit version allows the use for aftermarket dashes that provide wires from their system.   The connectors are a direct fit onto the factory 14-pin connectors in your dash.   No need to hack up your OEM wiring and can be reversed in the future.   Utilizing 18-awg Automotive grade TXL wire, the kit comes with wire loom and pre labeled wires with hardware to make your install EZ.    The factory connectors often have minimal length wires which makes splicing even more of a head ache.    We solve that problem for you!   Save time and frustration with the Digital EZ harness installation kits.

Note:  This kit can be used for both the 87-89 and 90-93 Mustangs.   Follow wire instructions as some wires won’t be used based on year of your car.

Contents:

• Digital EZ harness connectors (x2)

• Braided loom with shrink tubing

• Zip ties x2

• Heat shrink weatherproof butt connectors (x4)

• 1” x 1” peel and stick zip tie mounting pads

• Velcro pieces x2

• T-tap wire tap

• Self-tapping screw (for ground connection to chassis ground) (x1)

• Heat shrink weatherproof ring terminal for ground wire to chassis (x1)

• Labeled wires for speed sender, ground, 12V power, & GPS power

• ATC/ATO bladed fuse tap connector for connecting 12V power wire to fuse panel

• Now comes with alternator charging resistor (short kits only)

*Depending on your installation location & application extra butt connectors may be needed.

**Unused wire ends should be taped off or use shrink tubing.