Anderson Power Pipe®. Fits 96-04 GT & 96-01 Cobra Using Vortech or Paxton Supercharger (AF-0110A)

Anderson Power Pipe® 96-04 GT Mustang/Mach1/Bullit & 96-01 COBRA Using Vortech or Paxton SC's  (Please specify supercharger model when ordering)

We have seen an 8 rwhp improvement on the AFM dyno with no other changes than the Anderson Power Pipe® using the stock Vortech pullies. With smaller pullies we have seen increases of one to three pounds of boost over the standard Vortech inlet pipe

The AFM POWER PIPE®, with its all mandrel bent construction, is the highest flowing inlet pipe available for centrifugal superchargers. We also put the mass air in the inner fenderwell for a cooler intake charge.

AFM POWER PIPES® were developed because of the need for a supercharger intake pipe that would flow at a higher rate of CFM, with a larger volume of air, brought on by the demand that new Vortech, Procharger and Paxton have when making 10 lb of boost or more.

In the box:

S/C to Pipe 90 degree coupler, aluminum pipe, 90 degree bypass fitting, 4x4 inch humped coupler with 3.5 inch insert and clamps

Download Instructions


*Fits ProM 80mm/92mm, SCT BA2600/3000, Lightning and PMAS 80/90mm mass air meters

*This system was developed to work with the factory Vortech discharge systems both aftercooled and standard, if running a custom front mount intercooler modification may be required.

*Fitment is EXTREMELY tight, you are installing a piece that is 4" diameter in a spot designed for 3.5".

*Additional air lines may be required depending on model Vortech kit you are running (ex. double by-pass)