Anderson Power Pipe®. Fits 94-95 5.0L with Vortech S,T,YSI Trim Superchargers. (AF-0102C)

Anderson Power Pipe® for  Vortech,S,T,YSI Trims, Superchargers on 94-95 Mustang 5.0 
(Please specify supercharger model when ordering)

The Anderson Power Pipe®, with its all mandrel bent Ceramic Coated construction, is the highest flowing inlet pipe available for centrifugal superchargers. We also put the mass air in the inner fenderwell for a cooler intake charge.

Flows 1235 cfm at 20,4" of water. Tested on our Super Flow 1200 flow bench

Anderson POWER PIPES® were developed because of the need for a supercharger intake pipe that would flow at a higher rate of CFM, with a larger volume of air, brought on by the demand that Vortech, Procharger and Paxton have when making 10 lb of boost or more.

Pipe is 4" diameter (select S/C inlet above for proper 90 degree coupler)

Performance improvements with this innovative design have been fantastic! Muscle Mustangs & Fast Fords tested in their November '97 issue on two different cars. The first (minor modifications) went from 10 lb of boost to 14 lb of boost and dropped 2 tenths and gained 4 mph at the strip. The second (major modifications) went from 16 lb of boost to 19 lb of boost, gained 38 hp at the rear wheels, and dropped 23 hundredths and gained 1.5 mph at the strip.

Click for MM&FF Article

Download Instructions

*Fits ProM 80mm/92mm, SCT BA2600/3000 and PMAS 80/90mm mass air meters

*Note - requires cutting the factory fender apron for installation

* Requires relocating the air temperature sensor into the new rubber coupler by drilling a small hole and pushing the sensor into the rubber

* Depending on by-pass mounting location you may need extra 1" hose to connect from pipe to discharge pipe